The appearance and use of the automatic feeding mixer can provide many conveniences for various engineering construction, which are all the contributions of the automatic feeding mixer, and improve the operating efficiency of the equipment to the extent of use. In order to ensure the service performance of the automatic feeding mixer, one of the important parts is the transmission shifter. Every part will have some problems when it is used for a long time. How to repair it after it is damaged?
1、 Troubleshooting of hydraulic system or engine fault:
(1) Remove the high-pressure hose of the failed vehicle from the motor, connect the high-pressure hose for rescue, connect the other end to the oil pump of the rescue vehicle, and connect the end of the emergency oil return pipe to the motor of the failed vehicle. The other end of the oil return pipe is connected to the oil pump return port of the rescue vehicle, which is used to control the rotation of the mixing drum of the faulty vehicle.
(2) Open the inspection hole cover of the mixing pipe of the automatic feeding mixer truck, loosen the pipe joint of the high-pressure hose on the motor, rotate the mixing cylinder to tilt the mixing hole of the mixing cylinder downward, and discharge the mixing hole of the concrete mixing cylinder;
2、 Motor fault: the operation is relatively simple. The motor of the rescue vehicle can remove the fault vehicle, and then connect various oil pipes. Starting the rescue vehicle can discharge the sputum from the mixing drum.
In short, for the automatic feeding mixer, in case of failure, the cause of failure shall be determined in time, and measures shall be taken to eliminate the defects in the automatic feeding mixer before the failure is resolved.
The above is a detailed introduction to the automatic feeding mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude